 |
DIN plugs were added to the Array Solutions 6 Pak relay box to allow for
quick swap. |
 |
Two 6 Pak boxes are used to form a 12 Pak. All ports are marked for ease of
use. |
 |
This is the internal wiring changes to support the DIN jacks and 12 Pak
configuration. |
 |
The 6 Pak control boxes were also modified with DIN connectors. |
 |
Two 6 Pak Controllers were used to allow 2 antennas to be selected for any
band. |
 |
The Right Radio also uses a pair of 6 Pak controllers. |
 |
The Prosistel rotator control boxes, ICE 419 bandpass filters and Top Ten
band decoders. |
 |
The ICE 419 filters had to be modified to fully support the 12 Pak
SO2R configuration. |
 |
A view of the interior of the ICE 419 Bandpass filters. |
 |
This small circuit board implements the Amp Keying with TxEnable. The
ft1000MP transmit signal is synced with the Amp being ready. |
 |
A rear view of the connectors added to the Top Ten band decoders for the TxEnable
function. This mod eliminates the use of the TXGnd jack from the Yaesu. |
 |
The AY Technologies RAS 8 box. This box enables 8 RX antennas for SO2R
operation. The ICE 196 limiters were added to prevent receiver damage. |
 |
The interior of the ICE 196 Rx signal limiter. |
 |
A rear view of the RAS 8. Two conrollers allow a RX antenna to be used by
both SO2R positions. |
 |
A homebrew stack match control. See
Schematic for more details. |
 |
The 3 homebrew stack matches are used on 40, 80, 160. They are used for
power splitting not phasing. |
 |
The homebrew stack match remote relay box. |
 |
The interior of the homebrew stack match relay box. The relays are SPST 15
amp units. |
 |
All 6 of the Prosistel rotators are connecterized and can be moved for
Multi-op contests. |
|
|
